Nie jesteś zalogowany.
Jeśli nie posiadasz konta, zarejestruj je już teraz! Pozwoli Ci ono w pełni korzystać z naszego serwisu. Spamerom dziękujemy!

Ogłoszenie

Prosimy o pomoc dla małej Julki — przekaż 1% podatku na Fundacji Dzieciom zdazyć z Pomocą.
Więcej informacji na dug.net.pl/pomagamy/.

Strony: 1

 

#1  2010-12-31 15:50:37

  life - Użytkownik

life
Użytkownik
Zarejestrowany: 2009-10-30

WIFI Prism54 (PCI) działą tylko na kanale 1

Zgodnie z poradnikiem (http://wiki.debian.org/prism54)

Karta działa ale tylko na kanale 1

Kod:

[ 2082.002205] p54pci 0000:00:0e.0: PCI INT A disabled
[ 2082.261377] cfg80211: Using static regulatory domain info
[ 2082.330013] cfg80211: Regulatory domain: US
[ 2082.383836]  (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[ 2082.477719]  (2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 mBm)
[ 2082.563003]  (5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
[ 2082.648157]  (5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
[ 2082.733149]  (5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
[ 2082.817924]  (5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
[ 2082.902778]  (5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 mBm)
[ 2082.995413] cfg80211: Calling CRDA for country: US
[ 2083.226230] p54pci 0000:00:0e.0: PCI INT A -> Link[LNKA] -> GSI 10 (level, low) -> IRQ 10
[ 2083.332551] p54pci 0000:00:0e.0: firmware: requesting isl3886pci
[ 2083.431093] phy0: p54 detected a LM86 firmware
[ 2083.488820] p54: rx_mtu reduced from 3240 to 2376
[ 2083.549786] phy0: FW rev 2.13.12.0 - Softmac protocol 5.9
[ 2083.619195] phy0: cryptographic accelerator WEP:YES, TKIP:YES, CCMP:YES
[ 2084.555723] phy0: [curve data] is/are missing for channel:2 [2417 MHz].
[ 2084.640205] phy0: [curve data] is/are missing for channel:3 [2422 MHz].
[ 2084.724573] phy0: [curve data] is/are missing for channel:4 [2427 MHz].
[ 2084.808726] phy0: [curve data] is/are missing for channel:5 [2432 MHz].
[ 2084.892775] phy0: [curve data] is/are missing for channel:6 [2437 MHz].
[ 2084.976791] phy0: [curve data] is/are missing for channel:7 [2442 MHz].
[ 2085.060827] phy0: [curve data] is/are missing for channel:8 [2447 MHz].
[ 2085.144842] phy0: [curve data] is/are missing for channel:9 [2452 MHz].
[ 2085.228710] phy0: [curve data] is/are missing for channel:10 [2457 MHz].
[ 2085.313550] phy0: [curve data] is/are missing for channel:11 [2462 MHz].
[ 2085.398302] phy0: [curve data] is/are missing for channel:12 [2467 MHz].
[ 2085.482892] phy0: [curve data] is/are missing for channel:13 [2472 MHz].
[ 2085.567374] phy0: [curve data] is/are missing for channel:14 [2484 MHz].
[ 2085.651701] phy0: hwaddr xx:xx:xx:xx:xx:xx, MAC:isl3880 RF:Frisbee
[ 2085.734575] phy0: Selected rate control algorithm 'minstrel'
[ 2085.745246] Registered led device: p54-phy0::assoc
[ 2085.881275] Registered led device: p54-phy0::tx
[ 2085.954739] Registered led device: p54-phy0::rx
[ 2086.014082] Registered led device: p54-phy0::radio
[ 2086.075216] p54pci 0000:00:0e.0: is registered as 'phy0'

Kod:

iwlist wlan0 channel
wlan0     1 channels in total; available frequencies :
          Channel 01 : 2.412 GHz

Czy ktoś może spotkał się z czymś takim? Karta to miniPCI Prism54GT

Ostatnio edytowany przez life (2010-12-31 15:52:10)

Offline

 

#2  2010-12-31 15:53:38

  ilin - Palacz

ilin
Palacz
Skąd: PRLu
Zarejestrowany: 2006-05-03

Re: WIFI Prism54 (PCI) działą tylko na kanale 1

Sprawdź jak się będzie zachowywać pod ndiswrapperem i sterownikiem od XP

[b]Problemy rozwiązujemy na forum nie na PW[/b] -> Niech inni na tym skorzystają.
[url=http://dug.net.pl/]Polski portal Debiana[/url]

Offline

 

#3  2010-12-31 17:57:01

  Huk - Smoleńsk BULWA!

Huk
Smoleńsk BULWA!
Zarejestrowany: 2006-11-08

Re: WIFI Prism54 (PCI) działą tylko na kanale 1

A może w compat-wireless:

http://www.orbit-lab.org/kernel/compat-wireless-2.6-stable/v2.6.37/compat-wireless-2.6.37-rc6-3-sn.tar.bz2

są nowsze, lepsze stary?

Offline

 

#4  2011-01-01 23:42:03

  life - Użytkownik

life
Użytkownik
Zarejestrowany: 2009-10-30

Re: WIFI Prism54 (PCI) działą tylko na kanale 1

pomogło przez ndiswrapper (działa na wszystkich kanałach).

Ostatnio edytowany przez life (2011-01-01 23:42:20)

Offline

 

 

Strony: 1

Stopka forum

Powered by PunBB
© Copyright 2002–2005 Rickard Andersson
Możesz wyłączyć AdBlock — tu nie ma reklam ;-)

[ Generated in 0.007 seconds, 11 queries executed ]

Informacje debugowania

Time (s) Query
0.00008 SET CHARSET latin2
0.00004 SET NAMES latin2
0.00059 SELECT u.*, g.*, o.logged FROM punbb_users AS u INNER JOIN punbb_groups AS g ON u.group_id=g.g_id LEFT JOIN punbb_online AS o ON o.ident='3.147.62.99' WHERE u.id=1
0.00123 UPDATE punbb_online SET logged=1733025656 WHERE ident='3.147.62.99'
0.00033 SELECT * FROM punbb_online WHERE logged<1733025356
0.00037 SELECT topic_id FROM punbb_posts WHERE id=161726
0.00037 SELECT id FROM punbb_posts WHERE topic_id=18015 ORDER BY posted
0.00036 SELECT t.subject, t.closed, t.num_replies, t.sticky, f.id AS forum_id, f.forum_name, f.moderators, fp.post_replies, 0 FROM punbb_topics AS t INNER JOIN punbb_forums AS f ON f.id=t.forum_id LEFT JOIN punbb_forum_perms AS fp ON (fp.forum_id=f.id AND fp.group_id=3) WHERE (fp.read_forum IS NULL OR fp.read_forum=1) AND t.id=18015 AND t.moved_to IS NULL
0.00022 SELECT search_for, replace_with FROM punbb_censoring
0.00065 SELECT u.email, u.title, u.url, u.location, u.use_avatar, u.signature, u.email_setting, u.num_posts, u.registered, u.admin_note, p.id, p.poster AS username, p.poster_id, p.poster_ip, p.poster_email, p.message, p.hide_smilies, p.posted, p.edited, p.edited_by, g.g_id, g.g_user_title, o.user_id AS is_online FROM punbb_posts AS p INNER JOIN punbb_users AS u ON u.id=p.poster_id INNER JOIN punbb_groups AS g ON g.g_id=u.group_id LEFT JOIN punbb_online AS o ON (o.user_id=u.id AND o.user_id!=1 AND o.idle=0) WHERE p.topic_id=18015 ORDER BY p.id LIMIT 0,25
0.00090 UPDATE punbb_topics SET num_views=num_views+1 WHERE id=18015
Total query time: 0.00514 s